# What is normal operating temperature?

**URL:** <https://community.cartalk.com/t/what-is-normal-operating-temperature/181034>\
**Category:** Maintenance/Repairs\
**Tags:** engines, ford, ranger\
**Created:** [December 2, 2021, 11:39pm UTC](https://community.cartalk.com/t/what-is-normal-operating-temperature/181034 "2021-12-02T23:39:32Z")\
**Posts on this page:** 8\
**Page:** 1

<div class="post-metadata">

**Author:** ![gdan29](https://avatars.discourse-cdn.com/v4/letter/g/4bbf92/32.png) [@gdan29](https://community.cartalk.com/u/gdan29)\
**Post date:** [December 2, 2021, 11:39pm UTC](https://community.cartalk.com/t/what-is-normal-operating-temperature/181034/1 "2021-12-02T23:39:32Z")

</div>

The temperature gauge on my 2006 Ranger 2.3L is only 1/4 inch above the cold mark. I decided to replace the thermostat. I bought a Motorcraft 194 degrees, per spec…

Now the temp Gauge is close to the middle. I connected my Scan gauge to read the water temp. At idle in my driveway the temp is 215F and when I drive on some smaller hills the temp goes up to about 240F. The gauge stays in the middle.  
Is this a normal operating temp ? At what temp should I worry?

---

<div class="post-metadata">

**Author:** ![Mustangman](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/mustangman/32/44130_2.png) [@Mustangman](https://community.cartalk.com/u/Mustangman)\
**Post date:** [December 2, 2021, 11:47pm UTC](https://community.cartalk.com/t/what-is-normal-operating-temperature/181034/2 "2021-12-02T23:47:47Z")

</div>

215 is a little high for idle. 240 is more than a little high for down the road. You should be idling right at 195 and maybe 200 down the road. This assumes the sender in the engine sending info to your scanner is accurate. The gauge is reading “normal” but your scan readings need to be compared with another temp reader. I would suggest you use a non contacting IR temp gun.

---

<div class="post-metadata">

**Author:** ![Tester](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/tester/32/15976_2.png) [@Tester](https://community.cartalk.com/u/Tester)\
**Post date:** [December 2, 2021, 11:50pm UTC](https://community.cartalk.com/t/what-is-normal-operating-temperature/181034/3 "2021-12-02T23:50:50Z")

</div>

It depends on the operating conditions under which the vehicle is driven.

> **[A Guide to the Temperature Gauge in your Car: What’s Normal and What’s Not |...](https://www.vanchevrolet.com/blog/2017/june/19/a-guide-to-your-cars-temperature-gauge-whats-normal-and-whats-not.htm)**
>
> Your Chevy vehicle's instrumentation panel contains essential information about engine overheating. We all know how detrimental that is to any brand of car. When your engine gets too hot, internal damage can occur to components and the engine itself,...

Tester

---

<div class="post-metadata">

**Author:** ![George\_San\_Jose1](https://avatars.discourse-cdn.com/v4/letter/g/e5b9ba/32.png) [@George\_San\_Jose1](https://community.cartalk.com/u/George_San_Jose1)\
**Post date:** [December 2, 2021, 11:52pm UTC](https://community.cartalk.com/t/what-is-normal-operating-temperature/181034/4 "2021-12-02T23:52:25Z")

</div>

According to what I see the thermostat should begin to open at 194 F, and fully open by 223 F.

I don’t think the temperatures you are measuring indicate a malfunction. Make sure to use the proper coolant spec, replace it periodically, and bleed it of any air pockets, including in the heater core circuit. I presume you’ve already done that. Is the engine cooling fan turning on and spinning like a banshee when the coolant gets hot? If all that’s ok, probably no worries.

---

<div class="post-metadata">

**Author:** ![It\_s-Me](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/it_s-me/32/12660_2.png) [@It\_s-Me](https://community.cartalk.com/u/It_s-Me)\
**Post date:** [December 2, 2021, 11:54pm UTC](https://community.cartalk.com/t/what-is-normal-operating-temperature/181034/5 "2021-12-02T23:54:47Z")

</div>

2001-2011 Rangers with the 2.3l Duratec engines use a CHT(cylinder head temp) sensor NOT an ECT(engine coolant temp) sensor, so that’s what you see on the OBD reader  
And 230 to 250degF is about right, that’s NOT coolant temp, its head metal temp.

The dash gauge uses a 12volt temp SENDER, not a sensor, 1/2 way is about 205deg, just below 1/2 or 1/2 is normal on the 2.3l Duratec

---

<div class="post-metadata">

**Author:** ![Mustangman](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/mustangman/32/44130_2.png) [@Mustangman](https://community.cartalk.com/u/Mustangman)\
**Post date:** [December 3, 2021, 12:06am UTC](https://community.cartalk.com/t/what-is-normal-operating-temperature/181034/6 "2021-12-03T00:06:22Z")

</div>

My 5.0 also uses a CHT sensor and I don’t see 240 down the road nor do I see 215 at idle, but it is a different engine. But it has no sender or sensor for coolant. The gauge reading is software generated.

---

<div class="post-metadata">

**Author:** ![circuitsmith](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/circuitsmith/32/40376_2.png) [@circuitsmith](https://community.cartalk.com/u/circuitsmith)\
**Post date:** [December 3, 2021, 12:59am UTC](https://community.cartalk.com/t/what-is-normal-operating-temperature/181034/7 "2021-12-03T00:59:31Z")

</div>

If no other symptoms I’d put the scanner away for now and drive on.

---

<div class="post-metadata">

**Author:** ![gdan29](https://avatars.discourse-cdn.com/v4/letter/g/4bbf92/32.png) [@gdan29](https://community.cartalk.com/u/gdan29)\
**Post date:** [December 3, 2021, 3:04am UTC](https://community.cartalk.com/t/what-is-normal-operating-temperature/181034/8 "2021-12-03T03:04:15Z")

</div>

Thanks you for the information. Very helpful.
