# Water pump...replace?

**URL:** <https://community.cartalk.com/t/water-pump-replace/83918>\
**Category:** Maintenance/Repairs\
**Created:** [February 25, 2014, 9:03am UTC](https://community.cartalk.com/t/water-pump-replace/83918 "2014-02-25T09:03:35Z")\
**Posts on this page:** 8\
**Page:** 1

<div class="post-metadata">

**Author:** ![meanjoe75fan](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/meanjoe75fan/32/552_2.png) [@meanjoe75fan](https://community.cartalk.com/u/meanjoe75fan)\
**Post date:** [February 25, 2014, 9:03am UTC](https://community.cartalk.com/t/water-pump-replace/83918/1 "2014-02-25T09:03:35Z")

</div>

1994 F150, 164k mi. 4.9L I-6.

I’m in the middle of a head gasket job. While wait for the machine shop, I figured it’d be worth inspecting the water pump while it’s accessible.

But what constitutes a “bad” water pump? Impeller erosion, obviously, but what else? Bearing play?

Thsnks for input…including whether I should replace, inspect, or fuggetaboudit!

---

<div class="post-metadata">

**Author:** ![ok4450](https://avatars.discourse-cdn.com/v4/letter/o/e9bcb4/32.png) [@ok4450](https://community.cartalk.com/u/ok4450)\
**Post date:** [February 25, 2014, 9:07am UTC](https://community.cartalk.com/t/water-pump-replace/83918/2 "2014-02-25T09:07:57Z")

</div>

If the pump has never been replaced then I would do it if the truck were mine. The seals would be 20 years old and prone to failure at any time. My opinion is to be a bit pro-active with some things.  
A new thermostat is a must with every head gasket job.

---

<div class="post-metadata">

**Author:** ![BustedKnuckles](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/bustedknuckles/32/25_2.png) [@BustedKnuckles](https://community.cartalk.com/u/BustedKnuckles)\
**Post date:** [February 25, 2014, 9:18am UTC](https://community.cartalk.com/t/water-pump-replace/83918/3 "2014-02-25T09:18:08Z")

</div>

The three big water pump killers. 1) seal leak, 2) bearing play/noise, and 3) impeller erosion. Also, like @ok4450 said, if this is the original pump, or it is more than 7 years old, I’d replace it just because. It could save you the hassle of replacing it later due to reasons 1 or 2.

---

<div class="post-metadata">

**Author:** ![meanjoe75fan](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/meanjoe75fan/32/552_2.png) [@meanjoe75fan](https://community.cartalk.com/u/meanjoe75fan)\
**Post date:** [February 25, 2014, 9:22am UTC](https://community.cartalk.com/t/water-pump-replace/83918/4 "2014-02-25T09:22:48Z")

</div>

Thanks…I’ll replace it. I bought it with 124k on it, and I don’t know the history.

I’ll pass on the thermostat right now, because it didn’t overheat, the coolant temp is observed behaving normally, I’ll be driving it/monitoring it, and the thermostat is easily accessible even after full assembly.

One question, though: is it advisable (or even possible) to run “old-school” coolant? I read somewhere that OAT coolant really isn’t for cars with non-pressurized overflows, because it doesn’t play well with even traces of dissolved oxygen in the coolant system.

---

<div class="post-metadata">

**Author:** ![ok4450](https://avatars.discourse-cdn.com/v4/letter/o/e9bcb4/32.png) [@ok4450](https://community.cartalk.com/u/ok4450)\
**Post date:** [February 25, 2014, 9:38am UTC](https://community.cartalk.com/t/water-pump-replace/83918/5 "2014-02-25T09:38:55Z")

</div>

Personally, I run old school green in every car our entire family has simply because it’s always been problem free.

One of my son’s car uses Dex-Cool and that car went through 3 water pumps in the first roughly 80k miles. It kept sludging up through repeated flushes and there were zero leaks and loss of coolant. After the 3rd pump I flushed it again, filled it with green, and it’s never had an issue with leaks, pump failures or sludging since and up to the current mileage of around 250k.

---

<div class="post-metadata">

**Author:** ![Tester](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/tester/32/15976_2.png) [@Tester](https://community.cartalk.com/u/Tester)\
**Post date:** [February 25, 2014, 9:44am UTC](https://community.cartalk.com/t/water-pump-replace/83918/6 "2014-02-25T09:44:14Z")

</div>

While you’re in there, might as well do the timing chain.

It’s probably stretched.

Tester

---

<div class="post-metadata">

**Author:** ![asemaster](https://avatars.discourse-cdn.com/v4/letter/a/5f9b8f/32.png) [@asemaster](https://community.cartalk.com/u/asemaster)\
**Post date:** [February 25, 2014, 9:50am UTC](https://community.cartalk.com/t/water-pump-replace/83918/7 "2014-02-25T09:50:22Z")

</div>

You’ve got the cooling system empty, the thermostat and housing are off, you’re proactively replacing the water pump, a new t-stat gasket will come with the head gasket set, you don’t know the service history of the car, why wouldn’t you replace the thermostat?

That truck originally came with old-school green coolant, that’s what I’d put in it.

Why does it need a head gasket?

---

<div class="post-metadata">

**Author:** ![meanjoe75fan](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/meanjoe75fan/32/552_2.png) [@meanjoe75fan](https://community.cartalk.com/u/meanjoe75fan)\
**Post date:** [February 25, 2014, 9:59am UTC](https://community.cartalk.com/t/water-pump-replace/83918/8 "2014-02-25T09:59:55Z")

</div>

No chain, just bakelite gears. It’s not an interference engine, so I’ll probably wait for issues, then upgrade to metal at that time.

I thought even “green stuff” was partially organic these days, unless you sought out “original formula” coolant.

I think the gasket was partially breached when I bought it and got worse. Ran fine, but a sound at WOT between knock and "pfft."  
Gradually got worse until it happened at half throttle or more…a precautionary compression test showed 150-170 on all cylinders except 95 on #3. Looked to be leaking toward the head bolt outward on the “non-intake/exhaust” side of the block.
