# Steering noise in 2001 Honda CR-V

**URL:** <https://community.cartalk.com/t/steering-noise-in-2001-honda-cr-v/51817>\
**Category:** Maintenance/Repairs\
**Tags:** cr-v, noises, steering, honda\
**Created:** [July 14, 2010, 1:32pm UTC](https://community.cartalk.com/t/steering-noise-in-2001-honda-cr-v/51817 "2010-07-14T13:32:38Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Freddy501](https://avatars.discourse-cdn.com/v4/letter/f/53a042/32.png) [@Freddy501](https://community.cartalk.com/u/Freddy501)\
**Post date:** [July 14, 2010, 1:32pm UTC](https://community.cartalk.com/t/steering-noise-in-2001-honda-cr-v/51817/1 "2010-07-14T13:32:38Z")

</div>

2001 CRV - steering noise.  
  
  
  
 We have a 2001 Honda CRV, 96,000 miles. We have a “creaking” noise from the steering rack when turning the steering wheel. Dealer says everything checks out ok- fluid is ok, freeplay is ok, etc. but they say the noise is in the rack.  
  
  
  
 The noise is there:  
  
 -Even moving the wheel only one inch or so, and persists when continuing to turn the wheel all the way.  
  
 -When turning the wheel to the left only, though this was elusive to isolate for awhile.  
  
 -When the ignition is off and wiggling the wheel.  
  
 -When engine is running (ie power steering is active) and car is parked, and when turning the wheel even slightly.  
  
 -When at low speeds and moderate speeds when making a corner turn.  
  
 -This noise is NOT associated with sharp turning or the extreme turning of the wheel.  
  
 -Don?t ?hear? it at higher speeds (say above 20mph) but I think that?s because of road and engine noise. (After all, it IS a CRV.)

---

<div class="post-metadata">

**Author:** ![Goldwing](https://avatars.discourse-cdn.com/v4/letter/g/e68b1a/32.png) [@Goldwing](https://community.cartalk.com/u/Goldwing)\
**Post date:** [July 14, 2010, 2:47pm UTC](https://community.cartalk.com/t/steering-noise-in-2001-honda-cr-v/51817/2 "2010-07-14T14:47:48Z")

</div>

My car makes a similar creaking noise under similar conditions. I solve it by forcing some 80W90 gear oil into a rubber boot around or near the ball joint.

Your grease zerk-free, no maintenance parts have probably lost some lubrication over the years and need a little boost.

Try lubing some of the parts until you hear it go away. If this works, you may have to do this once per year or more often.
