# Show 1847: Potter's wheel question

**URL:** <https://community.cartalk.com/t/show-1847-potters-wheel-question/131381>\
**Category:** The Show\
**Created:** [December 24, 2018, 11:04pm UTC](https://community.cartalk.com/t/show-1847-potters-wheel-question/131381 "2018-12-24T23:04:54Z")\
**Posts on this page:** 1\
**Showing post:** 3

<div class="post-metadata">

**Author:** ![George\_San\_Jose1](https://avatars.discourse-cdn.com/v4/letter/g/e5b9ba/32.png) [@George\_San\_Jose1](https://community.cartalk.com/u/George_San_Jose1)\
**Post date:** [December 24, 2018, 11:24pm UTC](https://community.cartalk.com/t/show-1847-potters-wheel-question/131381/3 "2018-12-24T23:24:44Z")

</div>

The caller intended to attach the wheel directly to the output shaft. Ray said a welder would probably have to weld on a flange. There’s no differential. The wheel’s plane from what I understood is oriented 90 degrees to the output shaft.

Edit: I got to thinking I’d read about this issue before here. Maybe this was the thread.

> [@The Potter's Wheel](https://community.cartalk.com/t/the-potters-wheel/40080):
>
> The idea sounds perfect for an inspired tinkerer. But…Tom and Ray: why didn’t a discussion of lubrication for the transmission come up? Transmssions typically are splash lubricated and standing it on end would create 2 problems:(1) the output bearings and gears would run dry and (2) the input seal is not intended to seal a sump, but to prevent splash lubrication from leaking. To make this a practical solution wouldn’t the lubrication have to be replaced with grease, or would a right…

It may be that the gears don’t need to be lubed in this application.

---

_[View the full topic](https://community.cartalk.com/t/show-1847-potters-wheel-question/131381)._
