I’m trying to install a push button to the dash and a horn. I don’t want to use the original wires and the old horn is dead, and I don’t want to fix it so the steering wheel can sound the horn. I bought a 2 terminal universal horn, a push button, and an inline fuse. Whenever I hook it up and touch …

If you have an ohm meter, the switch should be open (high resistance) normally, and less than 2 ohms when pushed. If the push button switch didn’t come with the horn, unless it was designed for a horn circuit you may run into problems. The switch has to be designed to handle the amount of curren…

It is less than 2, I tried it before and after clicking the button. As soon as I even touch the positive terminal, the horn honks, even after clicking the button and retrying several times

If the switch measures less than 2 ohms in both positions, that’s the problem. Faulty switch. Could be faulty for the reason mentioned above, not designed for that much current.

While the horn is blaring, push the button in and see if the horn stops. Tester

Brand name and part number of this switch?

I highly doubt the OP has that information. Everything sounds Jerry-Rigged to me. [image] Jerad1389: I bought a 2 terminal universal horn, a push button, and an inline fuse. But I don’t know what gives me that impression? Tester

Wolo low tone universal horn 310-2t Autocraft horn AC85929

shop.advanceautoparts.com/p/wolo-horn-wiring-kit-for-cars-trucks-and-motorcycles-hwk-1/10167422-p?c3ch=PLA&c3nid=10167422-P

why do you need a horn? i have used mine twice in the last yr. i think? i work next to large medical facility. there are 2 lanes on the side road. 1 is turn left, and the other is straight and right turn. yes there is no right turn lane. i go right. you see where this is going. the other day a group…

That’s fun. I live in the country and there are always animals out, so we learned when we were 16 to slow down and honk to scare them away from the road. Also, for the people unaware of other vehicles on the road when they drift out of their lane

Push Button Horn Installation

Maintenance/Repairs

Rod-Knox June 9, 2019, 3:40pm 16

I have never seen a horn that wasn’t grounded through the mounting base. Ohm across the two male connectors on the horn and if there is no resistance the horn must be controlled with positive current directly through the switch or better through a relay.

Topic		Replies	Views
Botched Wire Job Draining My Battery Maintenance/Repairs chrysler , electrical-wiring , town--country	20	5433	July 29, 2020
Installing a second horn Maintenance/Repairs	6	12880	November 17, 2012
Horn Stopped Working Maintenance/Repairs chevrolet , 1500	7	2434	April 29, 2020
How to wire a horn to a button instead of using the horn ring General Discussion mercury	4	12992	September 24, 2016
A Horny Question Maintenance/Repairs chevrolet , 2500	16	3562	March 21, 2013

Push Button Horn Installation

Related topics