# Passat b6 knocking

**URL:** <https://community.cartalk.com/t/passat-b6-knocking/82405>\
**Category:** Maintenance/Repairs\
**Created:** [November 27, 2013, 12:53am UTC](https://community.cartalk.com/t/passat-b6-knocking/82405 "2013-11-27T00:53:45Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![system](https://global.discourse-cdn.com/cartalk/original/3X/1/d/1d47c66a543aa6c5a7873bb2320858f978ff52ed.png) [@system](https://community.cartalk.com/u/system)\
**Post date:** [November 27, 2013, 12:53am UTC](https://community.cartalk.com/t/passat-b6-knocking/82405/1 "2013-11-27T00:53:45Z")

</div>

Hi guys, a quick question about something that has been irritating me for around a year now. I have a 2006 2.0tdi and when driving at over 40 mph I get a kind off tap tap tap . If I put a little pressure on the clutch you really can feel the tapping. If I take the car out of gear the tapping goes. If I rev the engine whilst stationary no tapping. I figured it might be a worn spline on the driveshaft? Anyone have any ideas?? I’ve taken it to the local vw dealer 3 times and they can’t find anything.

---

<div class="post-metadata">

**Author:** ![system](https://global.discourse-cdn.com/cartalk/original/3X/1/d/1d47c66a543aa6c5a7873bb2320858f978ff52ed.png) [@system](https://community.cartalk.com/u/system)\
**Post date:** [November 28, 2013, 10:49pm UTC](https://community.cartalk.com/t/passat-b6-knocking/82405/2 "2013-11-28T22:49:23Z")

</div>

Just got her back from the mechanics after 30,000 mile service… They still couldn’t find the problem

---

<div class="post-metadata">

**Author:** ![the\_same\_mountainbike](https://avatars.discourse-cdn.com/v4/letter/t/c89c15/32.png) [@the\_same\_mountainbike](https://community.cartalk.com/u/the_same_mountainbike)\
**Post date:** [November 29, 2013, 11:53pm UTC](https://community.cartalk.com/t/passat-b6-knocking/82405/3 "2013-11-29T23:53:37Z")

</div>

Sounds to me like either a clutch assembly problem or something “down the line”, that only taps when under load, like a CV joint.

Does turning make any difference?
