# Installing trim

**URL:** <https://community.cartalk.com/t/installing-trim/74186>\
**Category:** Maintenance/Repairs\
**Tags:** chevrolet\
**Created:** [August 20, 2012, 1:11am UTC](https://community.cartalk.com/t/installing-trim/74186 "2012-08-20T01:11:29Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Impala\_girl](https://avatars.discourse-cdn.com/v4/letter/i/5daacb/32.png) [@Impala\_girl](https://community.cartalk.com/u/Impala_girl)\
**Post date:** [August 20, 2012, 1:11am UTC](https://community.cartalk.com/t/installing-trim/74186/1 "2012-08-20T01:11:29Z")

</div>

I am trying to install rear quarter panel trim on my 66 impala. I cannot figure out how to put it on. I replaced the push in clips but I am not sure of the orientation of the bolt on clip. It looks like it. Should just snap on. Any ideas?

---

<div class="post-metadata">

**Author:** ![oldbodyman](https://avatars.discourse-cdn.com/v4/letter/o/bbce88/32.png) [@oldbodyman](https://community.cartalk.com/u/oldbodyman)\
**Post date:** [August 20, 2012, 1:20am UTC](https://community.cartalk.com/t/installing-trim/74186/2 "2012-08-20T01:20:58Z")

</div>

If I remember right, the bolt on clip go’s into the trim first. You turn it to make it fit or it slips into the trim.