# Engine dies after reaching operating temperature

**URL:** <https://community.cartalk.com/t/engine-dies-after-reaching-operating-temperature/5580>\
**Category:** Maintenance/Repairs\
**Created:** [October 7, 2007, 2:56am UTC](https://community.cartalk.com/t/engine-dies-after-reaching-operating-temperature/5580 "2007-10-07T02:56:30Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![colby17](https://avatars.discourse-cdn.com/v4/letter/c/d78d45/32.png) [@colby17](https://community.cartalk.com/u/colby17)\
**Post date:** [October 7, 2007, 2:56am UTC](https://community.cartalk.com/t/engine-dies-after-reaching-operating-temperature/5580/1 "2007-10-07T02:56:30Z")

</div>

1989 Ford F250 has rebuilt engine and was working fine for 2 months. Now the engine is dying after warming up. When it is cold, it starts up with no problem. The hand held emission system checker is reporting no problems, it is reporting system pass. Does anyone have any ideas?  
  
 Thank you, colby

---

<div class="post-metadata">

**Author:** ![Tester](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/tester/32/15976_2.png) [@Tester](https://community.cartalk.com/u/Tester)\
**Post date:** [October 7, 2007, 3:14am UTC](https://community.cartalk.com/t/engine-dies-after-reaching-operating-temperature/5580/2 "2007-10-07T03:14:44Z")

</div>

If the ignition module is the orginal, I would suspect that’s what’s cutting out.

Ain’t it drag when you rebuild an engine, only to find out the ancellary components start to give out?

Tester

---

<div class="post-metadata">

**Author:** ![mr\_josh](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/mr_josh/32/3008_2.png) [@mr\_josh](https://community.cartalk.com/u/mr_josh)\
**Post date:** [October 7, 2007, 3:16am UTC](https://community.cartalk.com/t/engine-dies-after-reaching-operating-temperature/5580/3 "2007-10-07T03:16:16Z")

</div>

Right off the bat, I’d assume ECT (engine coolant temp) sensor. It reports the engine temperature to the computer and when the engine is warm enough, the computer comes out of open loop mode and starts taking readings from the O2 sensors.

Secondary to that, it could be an ignition coil or TFI module.

---

<div class="post-metadata">

**Author:** ![ok4450](https://avatars.discourse-cdn.com/v4/letter/o/e9bcb4/32.png) [@ok4450](https://community.cartalk.com/u/ok4450)\
**Post date:** [October 7, 2007, 4:47am UTC](https://community.cartalk.com/t/engine-dies-after-reaching-operating-temperature/5580/4 "2007-10-07T04:47:03Z")

</div>

I’ll second Tester on the module since you have one of those TFI-IV vehicles.
