# Bosch Universal O2 Sensor

**URL:** <https://community.cartalk.com/t/bosch-universal-o2-sensor/36741>\
**Category:** Maintenance/Repairs\
**Tags:** nissan, altima\
**Created:** [September 16, 2009, 8:38pm UTC](https://community.cartalk.com/t/bosch-universal-o2-sensor/36741 "2009-09-16T20:38:37Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![BigEdd](https://avatars.discourse-cdn.com/v4/letter/b/e19adc/32.png) [@BigEdd](https://community.cartalk.com/u/BigEdd)\
**Post date:** [September 16, 2009, 8:38pm UTC](https://community.cartalk.com/t/bosch-universal-o2-sensor/36741/1 "2009-09-16T20:38:37Z")

</div>

Wiring a Bosch 02 sensor in a 99 Nissan Altima. Original sensor was a 3 wire, the Bosch is a 4 wire, I have Black to Black, Gray to Gray and 1 white wire to white. My question is should I splice the 2 white wires on the Bosch together and connect them to the 1 white on the harness?

---

<div class="post-metadata">

**Author:** ![Tester](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/tester/32/15976_2.png) [@Tester](https://community.cartalk.com/u/Tester)\
**Post date:** [September 16, 2009, 9:01pm UTC](https://community.cartalk.com/t/bosch-universal-o2-sensor/36741/2 "2009-09-16T21:01:08Z")

</div>

Are you sure you’ve got the right O2 sensor? The O2 sensor before the cat is a three wire sensor. The O2 sensor after the cat is a four wire sensor.

Tester

---

<div class="post-metadata">

**Author:** ![BigEdd](https://avatars.discourse-cdn.com/v4/letter/b/e19adc/32.png) [@BigEdd](https://community.cartalk.com/u/BigEdd)\
**Post date:** [September 17, 2009, 12:31am UTC](https://community.cartalk.com/t/bosch-universal-o2-sensor/36741/3 "2009-09-17T00:31:29Z")

</div>

According to NAPA this is the correct one, I tried tonight splicing the 2 whites together and connecting them to the white on the harness. Car runs fine, no skips, no slughishness. I guess I will stop by NAPA and have then reset the “Check Engine Light” then see if it kicks a code back at me.

---

<div class="post-metadata">

**Author:** ![MikeInNH](https://avatars.discourse-cdn.com/v4/letter/m/a587f6/32.png) [@MikeInNH](https://community.cartalk.com/u/MikeInNH)\
**Post date:** [September 17, 2009, 2:02pm UTC](https://community.cartalk.com/t/bosch-universal-o2-sensor/36741/4 "2009-09-17T14:02:13Z")

</div>

Doesn’t sound like you have the right sensor to me. When I had a new exhaust system put on my 98 Pathfinder the guy accidentally destroyed one of the O2 sensors. He actually tried to use a Bosch sensor, but it didn’t work right…He then replaced it with one from NGK…worked fine.
