# 2010 Ford Transit Connect still shakes after repair

**URL:** <https://community.cartalk.com/t/2010-ford-transit-connect-still-shakes-after-repair/164282>\
**Category:** Maintenance/Repairs\
**Tags:** transit-connect, ford\
**Created:** [May 14, 2020, 4:10am UTC](https://community.cartalk.com/t/2010-ford-transit-connect-still-shakes-after-repair/164282 "2020-05-14T04:10:32Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![EvaPena](https://avatars.discourse-cdn.com/v4/letter/e/c4cdca/32.png) [@EvaPena](https://community.cartalk.com/u/EvaPena)\
**Post date:** [May 14, 2020, 4:10am UTC](https://community.cartalk.com/t/2010-ford-transit-connect-still-shakes-after-repair/164282/1 "2020-05-14T04:10:33Z")

</div>

i take my transit to mechanic shop for shake engine and they find out was on engine mount ,and they replace it …buth still doing the same problems …any idea what can be …

---

<div class="post-metadata">

**Author:** ![Nevada\_545](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/nevada_545/32/41232_2.png) [@Nevada\_545](https://community.cartalk.com/u/Nevada_545)\
**Post date:** [May 14, 2020, 5:26am UTC](https://community.cartalk.com/t/2010-ford-transit-connect-still-shakes-after-repair/164282/2 "2020-05-14T05:26:37Z")

</div>

One engine mount? They may need to replace every engine and transmission mount to eliminate this discomfort. Four cylinder engines are typically not vibration free so don’t be too particular.

---

<div class="post-metadata">

**Author:** ![davepsinbox\_157004](https://avatars.discourse-cdn.com/v4/letter/d/73ab20/32.png) [@davepsinbox\_157004](https://community.cartalk.com/u/davepsinbox_157004)\
**Post date:** [May 14, 2020, 4:28pm UTC](https://community.cartalk.com/t/2010-ford-transit-connect-still-shakes-after-repair/164282/3 "2020-05-14T16:28:28Z")

</div>

If the mounts are in good shape and the check engine light isn’t on you may have a cylinder with low compression. That would cause it to run rougher than normal.

---

<div class="post-metadata">

**Author:** ![LostnTransit](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/lostntransit/32/35072_2.png) [@LostnTransit](https://community.cartalk.com/u/LostnTransit)\
**Post date:** [July 9, 2023, 11:48am UTC](https://community.cartalk.com/t/2010-ford-transit-connect-still-shakes-after-repair/164282/4 "2023-07-09T11:48:54Z")

</div>

Someone must have cleared a misfire code which would part of the cylinder compression issues. Rough idle would tell me that one could be using bad fuel and this needs to be changed. plus one should avoid the STP stuff. However I would try the gumout tune up fliud.