# 2007 Chrysler Town and Country Rear Disc Brakes **URL:** \ **Category:** Maintenance/Repairs\ **Tags:** brakes, repair\ **Created:** [November 18, 2008, 7:15pm UTC](https://community.cartalk.com/t/2007-chrysler-town-and-country-rear-disc-brakes/22245 "2008-11-18T19:15:57Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![nc5fitch](https://avatars.discourse-cdn.com/v4/letter/n/94ad74/32.png) [@nc5fitch](https://community.cartalk.com/u/nc5fitch)\ **Post date:** [November 18, 2008, 7:15pm UTC](https://community.cartalk.com/t/2007-chrysler-town-and-country-rear-disc-brakes/22245/1 "2008-11-18T19:15:57Z")
I was trying to replace the pads on my 2007 Town and Country and cannot get the caliper to come off of rotor. I removed the two bolts holding the caliper onto the brakes. The caliper is loose but will not come off of the rotor/pads. Is there a third bolt that needs to come out or do I just need to somehow push the piston back to get it around the pads? ---
**Author:** ![MikeInNH](https://avatars.discourse-cdn.com/v4/letter/m/a587f6/32.png) [@MikeInNH](https://community.cartalk.com/u/MikeInNH)\ **Post date:** [November 18, 2008, 8:02pm UTC](https://community.cartalk.com/t/2007-chrysler-town-and-country-rear-disc-brakes/22245/2 "2008-11-18T20:02:16Z")
Try loosening the bleeder screw. Last Chryco I replaced the brakes on only had ONE bolt to remove. Then the caliper swiveled up. ---
**Author:** ![Tester](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/tester/32/15976_2.png) [@Tester](https://community.cartalk.com/u/Tester)\ **Post date:** [November 18, 2008, 11:24pm UTC](https://community.cartalk.com/t/2007-chrysler-town-and-country-rear-disc-brakes/22245/3 "2008-11-18T23:24:30Z")
You may have to slip a small pry bar between the caliper and caliper mounting bracket to remove the caliper from the rotors/pads. Tester