# 05 Pontiac vibe blower motor

**URL:** <https://community.cartalk.com/t/05-pontiac-vibe-blower-motor/86274>\
**Category:** Maintenance/Repairs\
**Created:** [July 29, 2014, 4:12am UTC](https://community.cartalk.com/t/05-pontiac-vibe-blower-motor/86274 "2014-07-29T04:12:47Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Scotiamike](https://avatars.discourse-cdn.com/v4/letter/s/85f322/32.png) [@Scotiamike](https://community.cartalk.com/u/Scotiamike)\
**Post date:** [July 29, 2014, 4:12am UTC](https://community.cartalk.com/t/05-pontiac-vibe-blower-motor/86274/1 "2014-07-29T04:12:47Z")

</div>

I recently got another blower motor for my vibe. Got it installed but nothing happened. I replaced the resistor as well. Once I found the secret hidden fuse panel I found that the 40a fuse was blown. I replaced it and it blew instantly upon turning the ignition on, the resistor was unplugged at the time. I am wondering if there could be a short in the wire harness.

The blower went bad a while ago and blew a resistor, I replaced it and it ran for a while until some smoke came out of the dash and then nothing.

---

<div class="post-metadata">

**Author:** ![insightful](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/insightful/32/2732_2.png) [@insightful](https://community.cartalk.com/u/insightful)\
**Post date:** [July 29, 2014, 6:17am UTC](https://community.cartalk.com/t/05-pontiac-vibe-blower-motor/86274/2 "2014-07-29T06:17:26Z")

</div>

Sure sounds like a short in the dash of the power wire to the blower control switch. Look around under the dash with a flashlight for a charred wire, especially around the pedals.

---

<div class="post-metadata">

**Author:** ![BustedKnuckles](https://sea1.discourse-cdn.com/cartalk/user_avatar/community.cartalk.com/bustedknuckles/32/25_2.png) [@BustedKnuckles](https://community.cartalk.com/u/BustedKnuckles)\
**Post date:** [July 29, 2014, 6:25am UTC](https://community.cartalk.com/t/05-pontiac-vibe-blower-motor/86274/3 "2014-07-29T06:25:55Z")

</div>

If the fan switch is on ‘high’, the resistor pack is bypassed. It may not need to be plugged in.
