Greetings all, I have a wiring issue. I have found a broken conductor in my brake light system, which causes my right and high-mount brake lights not to function. If I give the wire a good wiggling and fanangaling, I can get all the brake lights to come on, but eventually they go out again after dri…

They make a tool that releases the terminals from the connector. However sometimes a paper clip or a scribe can be used to release the terminals. Here’s a link that describes how to remove terminals from connectors. http://99mpg.com/mima/pininstall/installation/05openingtheharness/ Tester

Thanks for the link tester. I have to get up close to my own connector again to make sure it is the same lock.

The tools aren’t expensive. You can get them on line or at Radio Shack.

I just looked at my connector up close again, and I can’t seem to figure out where I would insert that U shaped tool. There are no real holes or gaps on either side of the connector. Does that sound right? The linked instructions didn’t actually show where they were putting it in.

Wire connectors in 1992 Honda Accord

Maintenance/Repairs

pleasedodgevan2 April 30, 2012, 9:12am 5

If that connector plugs into another connector with wires on it, some mechanics would just cut the wire on both sides of the connector and just bypass the connector. Wire is cheap after all.

Topic		Replies	Views
Removing Connector From Brake Light Switch (2010 Chrysler) Maintenance/Repairs sebring , chrysler	5	4097	November 19, 2016
Damsel in distress over shot headlight bulb Maintenance/Repairs	13	1368	May 31, 2009
Brake Lights Maintenance/Repairs	5	699	July 13, 2007
High mount brake light wire broke Maintenance/Repairs hyundai , elantra	13	3807	April 10, 2023
Weird Brake Light Problem Maintenance/Repairs electrical-wiring , brakes , lights	2	378	October 1, 2008

Wire connectors in 1992 Honda Accord

Related topics