2007 Jeep Liberty - Help ! Can’t get the oil dipstick back into the tube! Goes in about 3/4 of the way and jams - feels like it’s hanging up on something. This is what I did: pulled it out, wiped it off, slipped it back in, pulled it out again to check the oil. Now it won’t go back in. (No - I di…

Some dipsticks will only go into the tube one way, and not the other, due to a bend in the tube. Try rotating the dipstick 180 degrees and then try again to insert it.

Yep, ll you have to do is twist it.

You can still drive your Jeep even without a dipstick.

Thanks, Steve - I really appreciate your following up with the second part of my question. I’ve driven the car about a mile and tried again to reinsert the stick. As far as it goes in, the stick comes back out dry. Just worried that the 30 mile one way drive to work could be a problem. Don’t wan…

Maybe the base of the tube has come dislodged from where it attaches to the engine. I’d be afraid of the oil coming out of that hole, and I’d drive it straight to the shop. What happens when you run the engine for 5-10 seconds, is there oil under the car?

Thanks so much for you comment - very logical. Been out on several short trips this morning, maybe 1.5 mi each - no oil under the car ( crawled underneath with a flashlight) no oil under the hood. Dipstick still won’t go in more than 60-70% of its length, and what does go in comes out completely o…

“…and what does go in comes out completely oil free.” That is expected. If you can’t get it in all the way except for about 2 inches, the dipstick will not get wet. I wouldn’t worry about that at all for now. It will only become a problem when you really do need to check your oil level. Try pus…

I Don’t Know If You’ve Tried, But Grasp The Actual Dipstick Just Above The Tube (Instead Of The Handle) And While Turning It Clockwise (Like You’re Screwing It In), “Feed” It Into The Tube. This Allows You To Push A Little Harder Without Kinking The Dipstick. The reason some dipsticks have a “twist…

Just let the handle on the dipstick rotate as you put it into the hole and your problem should be over.

Dipstick won't go back in the tube!

Maintenance/Repairs

3CatGal November 5, 2011, 6:00pm 4

Thanks - I’ve tried this repeatedly, every which way. It just won’t go!

Topic		Replies	Views
Broken dip stick Maintenance/Repairs dodge , stratus	6	975	May 7, 2010
2005 escalade.... Can i drive if the dip stick came out of engine? Maintenance/Repairs	18	5515	April 17, 2019
Broken distick housing Maintenance/Repairs	3	526	September 9, 2007
Dip Stick broken Maintenance/Repairs nissan , sentra	16	21537	September 28, 2010
Dipstick Broken Off in Tube Maintenance/Repairs	9	11237	May 4, 2008

Dipstick won't go back in the tube!

Related topics